How To Fix Grainy And Overcooked Fudge So It's Soft Again (2024)

Brian Udall

·2 min read

How To Fix Grainy And Overcooked Fudge So It's Soft Again (1)

It's the holiday season, and you've made a batch of fudgefor friends and family, but you've just had a bite, and the texture is off. It tastes fine, except there's a graininess or a grittiness to the fudge that's unpleasant. Or, maybe the fudge is hard, brittle, and overcooked. The grittiness comes from sugar crystals that didn't dissolve into the fudge during the cooking process. Hard and overcooked fudge isn't great, either, but before you throw the whole pan out, try this simple trick.

For both problems, you'll need to melt the fudge back down to allow the sugar crystals to properly dissolve or to allow the overcooked fudge to soften up again. It may seem counterintuitive to cook overcooked fudge even more, but trust us, you just need to start the fudge over from scratch. Of course, if the fudge is burnt, that's a different problem, and cooking it again won't remove the burnt flavor. Grab the saucepan that you initially used to cook the fudge and toss the fudge back in along with 1 ½ cups of water and a splash of cream. Adding some cream of tartar is a helpful way to keep the sugar crystals at bay as well — it's not essential, but if you have some, definitely pour a little in. Bring the fudge to a boil slowly. You want the sugar to dissolve before it boils, so make sure the fudge is smooth before turning the heat up.

Read more: Chocolate Brands, Ranked Worst To Best

Other Tips To Avoid Bad Fudge

How To Fix Grainy And Overcooked Fudge So It's Soft Again (2)

A great way to make sure your fudge is going to settle right is by using a candy thermometer. When bringing your fudge to a boil, check that the temperature reaches the ideal range of 237 to 239 F. That range will get you a pan of fudge that's in the Goldilocks zone of not too soft and not too hard. It will also help keep your fudge from becoming gritty since sugar crystals can form again if the fudge gets too hot. Overcooked fudge, which goes beyond 239 F, evaporates the water, which isn't what you want.

ADVERTIsem*nT

It also matters how you treat the fudge after it's cooked. Avoid too much stirring while you are heating the fudge since this agitates the sugar and causes it to clump into sugar crystals again. Once it's reached 237 F, allow the fudge to cool to 110 F, and don't stir the fudge at all while it's cooling. Less is more in this case. Other than these tips, treat the fudge like you normally would, and you'll have breathed new life into your winter treat.

Read the original article on Tasting Table.

How To Fix Grainy And Overcooked Fudge So It's Soft Again (2024)

FAQs

How To Fix Grainy And Overcooked Fudge So It's Soft Again? ›

To fix oily, hard or grainy fudge, scoop the fudge back into a pot with about a cup of water. Cook it over low heat until the fudge dissolves. Then bring the fudge back up to the temperature specified in the recipe and follow the remaining steps. The flavor may be slightly diluted, but the texture will be improved.

How to soften overcooked fudge? ›

Grab the saucepan that you initially used to cook the fudge and toss the fudge back in along with 1 ½ cups of water and a splash of cream. Adding some cream of tartar is a helpful way to keep the sugar crystals at bay as well — it's not essential, but if you have some, definitely pour a little in.

What happens if you overcook fudge? ›

Too cooked

This fudge was cooked to a temperature of 118 °C (244 °F). At this temperature, the sugar is too concentrated and there is not enough water left to form syrup around sugar crystals. The result is hard and brittle fudge.

What to do with fudge that didn't harden? ›

OPTION 1) Depending on how runny it is, you can either use it as a frosting for cakes, or a sauce for ice-cream. OPTION 2) Freeze it overnight. Cut it into squares. Cover each square thickly in melted chocolate, ensuring no part of the fudge is exposed.

Can you save overcooked fudge? ›

The solution? A fudge do-over. Even though it set up properly, I threw it back into a saucepan with about 1 1/2 cups of water and gently heated the mixture to dissolve the fudge into the water. From there, I pretty much re-did the whole cooking process.

Why is my homemade fudge too hard? ›

If there is too much evaporation, when the cooking time is too long, there will not be enough water left in the fudge and it will be too hard. Conversely, if the cooking time is too brief and there is not enough evaporation, too much water will remain and the fudge will be too soft.

How to fix fudge that won't set? ›

How can you fix soft fudge? Put it in a microwave safe bowl that is large enough that it won't boil over. Reheat it to the boiling point and cook for about 3 more minutes. Then you can beat some powdered sugar into it if this doesn't make it set.

What to do with failed fudge? ›

My advice to you is to just pour it in a jar, call it something else delicious, and pretend you meant for it to be that way. The nice thing about my “failed” fudge is that it tastes absolutely delicious! A spoonful of the delectable treat will make you want for more.

Why did my fudge turn out grainy? ›

Graining can be caused by stirring the fudge mixture during the cooling process or not adding enough fluid to dissolve the sugar. The trick to fixing graininess is to melt the sugar crystals to give them another chance at setting properly.

Can I fix hard fudge? ›

To fix it, you can reheat the fudge mixture over low heat and continue cooking until it reaches the proper temperature. Be sure to use a candy thermometer to monitor the temperature accurately. Alternatively, you can try to salvage chewy fudge by mixing it into ice cream or using it as a topping for desserts.

Should you stir fudge while it's boiling? ›

You should mix the cream, butter, and sugar when making your fudge, but put down the spoon once it has reached its boiling point. Stirring while your sugar mixture is boiling will only form sugar crystals and make your fudge crunchy rather than silky smooth.

What is the soft ball stage of fudge? ›

making of fudge

termed in kitchen parlance the soft ball stage, that point between 234 and 240 °F (112 and 115 °C) at which a small ball of the candy dropped in ice water neither disintegrates nor flattens when picked up with the fingers.

Why is my fudge sandy? ›

If your fudge is tough, hard, or grainy, then you may have made one of several mistakes: You may have overcooked it, beaten it too long, or neglected to cool it to the proper temperature.

What should fudge look like after beating? ›

The fudge is then beaten as this makes the fudge slightly crumbly rather than chewy. Beating the mixture encourages the formation of small sugar crystals, which leads to the crumbly texture. The crystals may not be noticeable in themselves but the fudge mixture will thicken and turn from shiny to matte in appearance.

How long does old fashioned fudge last? ›

The best way to store fudge is cut into squares and placed in an airtight container. You can store fudge at room temperature for up to two weeks or in the refrigerator for up to three weeks. Be sure to place a piece of parchment paper or aluminum foil between each layer of fudge in the container.

Why is some fudge hard and some soft? ›

If you don't heat your fudge to a high enough temperature, you'll end up with a soft product. And if you heat the mixture too much, your fudge may be harder than you'd like.

Why won't my 3 ingredient condensed milk fudge set? ›

This often happens when the condensed milk and chocolate chip mixture isn't hot enough to start. Everything must be completely melted before it is transferred to the pan to cool. Heat in 30-second bursts in the microwave, stirring well between each to ensure everything is melting evenly.

Top Articles
Latest Posts
Article information

Author: Wyatt Volkman LLD

Last Updated:

Views: 6167

Rating: 4.6 / 5 (66 voted)

Reviews: 81% of readers found this page helpful

Author information

Name: Wyatt Volkman LLD

Birthday: 1992-02-16

Address: Suite 851 78549 Lubowitz Well, Wardside, TX 98080-8615

Phone: +67618977178100

Job: Manufacturing Director

Hobby: Running, Mountaineering, Inline skating, Writing, Baton twirling, Computer programming, Stone skipping

Introduction: My name is Wyatt Volkman LLD, I am a handsome, rich, comfortable, lively, zealous, graceful, gifted person who loves writing and wants to share my knowledge and understanding with you.